crow
03-30-2005, 10:46 PM
If an opacity operation is keyed into a spline could there be some kind of indication on screen that this has happened, ie, the 'transform' box is made of dashes rather than a solid line?
Or a small letter (near a corner of the transform box or in the centre of the spline) to indicate degrees of visibility: 'O' or 'X' for off and 'T' for degrees of transparency (1%-99%). Could be activated by the '.' (period) key. Same as the centre point.
It gets a little hard to sort out what's on/off/transparent when there's a screen full of splines going on and off at different times.
Cheers.
Or a small letter (near a corner of the transform box or in the centre of the spline) to indicate degrees of visibility: 'O' or 'X' for off and 'T' for degrees of transparency (1%-99%). Could be activated by the '.' (period) key. Same as the centre point.
It gets a little hard to sort out what's on/off/transparent when there's a screen full of splines going on and off at different times.
Cheers.